Arrow Group Industries Inc

It is marketed and stated on box 8 x 10 ft shed. After opening and assembling the shed I attempted to install the 4×8 sheets of flooring. The inside measurements of the building meant I had to cut 8 inches off the length of the 4×8 by 8 inches to fit the suppose 8ft width. Then I had to cut the narrow 4×8 sheet to 22 inches to fit the suppose 10 length.

That is a lot of waste. The flooring supports cover the inside length. It does not support the full width. The walls have a lip to support the flooring, EXCEPT the sheets of flooring at the entrance are not supported until 10 inches in. There is no support lip in the sliding door track. This makes the floor bounce.

The flooring supports do not connect to the front and back walls like they do for the side walls. As you enter a lawn tractor. The wheels pull the door track and the front wall out. I am 5ft 6 inches. I have hit my head several times on the joists. The approx 71 inch height is at the outside peek. There are 3, 6in joists to support the roof. That makes the inside very low. I had to put pipe insulation foam tubes over the bottoms of the joists to protect my head.